Can I/O

Add extra Inputs and outputs over Can Bus for your ECU.
5x Analogue 0-5 volt inputs. Use for sensor inputs.
8x Digital 0-5 volt Inputs. Use for switched on/off inputs.
4x Digital Switch to ground outputs for driving relays. Use for extra fans, start button etc.

The Can I/O can be used by itself using its default settings and addresses, but add one of the can bus displays and it's fully programmable as the displays have the software default in them. The display also monitors all inputs and outputs in real time so you can see the functions working.

Can I/O uses a TE Superseal 26 pin connector, comes with main connector and pins.

Please note these controllers are DIY EFI (Aftermarket and possibility not road legal).
The user must have some degree of knowledge of how a engine works and Electronic Fuel Injection systems and Electrical wiring.
As this is a DIY, I take no responsibility on how it is used and damage or harm it could cause.
There is no warranty or responsibility implied in anyway.
I will help and support in any way possible and warranty against manufacturing defects.
Physical damage, Vehicle associated or incorrect wiring will not be covered.