4 Channel programmable Ignition only module.

In stock
Product Details

4 Channel programmable Ignition only module.

5volt ignition smart coil or to ignitor output.

Built in MAP sensor.

TPS and Coolant input.

2 low current outputs for Fuel pump and thermo fan control.

Tach output.

Crank and CAM inputs, Hall Sensor only on this model.

Multiple trigger pattern configurations available.

Uses Tuner Studio for programing and USB connection.

Comes in a printed case as pictured.
14 pin plug end and crimp ends to make your wiring harness

All units are tested on a running engine before sending out.
Please allow approximately 5-7 day lead time for unit to be built and tested.
Every unit is hand assembled at the time of ordering. Takes me around 4 hours to assemble one unit without any accessories.

Please note these controllers are DIY EFI (Aftermarket and possibility not road legal).

The user must have some degree of knowledge of how a engine works and Electronic Fuel Injection systems and Electrical wiring.
As this is a DIY, I take no responsibility on how it is used and damage or harm it could cause.
There is no warranty or responsibility implied in any way.
I will help and support in any way possible and warranty against manufacturing defects.
Physical damage, Vehicle associated or incorrect wiring will not be covered.

Save this product for later