{"id":135,"date":"2021-03-07T03:15:33","date_gmt":"2021-03-07T03:15:33","guid":{"rendered":"http:\/\/www.everythingfuelinjection.com\/?p=135"},"modified":"2021-04-22T21:50:17","modified_gmt":"2021-04-22T21:50:17","slug":"the-new-pro-ecu-has-arrived","status":"publish","type":"post","link":"https:\/\/www.everythingfuelinjection.com\/site\/ecus\/the-new-pro-ecu-has-arrived\/","title":{"rendered":"The NEW Pro ECU has arrived"},"content":{"rendered":"\n

Stm32F407 MCU Processor gives it the ability for more outputs.<\/p>\n\n\n\n

8 x injectors (high current)<\/p>\n\n\n\n

8 x Ignition Output (selectable 5\/12v) Coils with ignitors<\/p>\n\n\n\n

(Firmware will run sequential 8×8 ignition\/Injection)<\/p>\n\n\n\n

4 x High current (vvt , boost, idle 1, idle2)<\/p>\n\n\n\n

1 x High current High side output (12 volt Positive, can drive V-Tech solenoid)<\/p>\n\n\n\n

3 x low current, Fuel pump, Fan, Spare<\/p>\n\n\n\n

(Total of 13 High Current outputs)<\/p>\n\n\n\n

(Total of 3 Low current outputs)<\/p>\n\n\n\n

Coolant<\/p>\n\n\n\n

Intake air temp<\/p>\n\n\n\n

TPS<\/p>\n\n\n\n

MAP (internal + External) 250kpa or 400kpa available<\/p>\n\n\n\n

O2 analog Input (Wideband and narrow)<\/p>\n\n\n\n

4 x extra analog inputs 0-5v linear (Oil,Fuel pressure etc, Can be configured as temperature with bias resistor jumper)<\/p>\n\n\n\n

(Total of 9 external Analog inputs)<\/p>\n\n\n\n

Built in Dual VR Conditioner MAX9926 (selectable VR or HALL<\/p>\n\n\n\n

Baro Internal<\/p>\n\n\n\n

Flex input<\/p>\n\n\n\n

3 x Digital inputs (VSS etc)<\/p>\n\n\n\n

Tach output (5v-12V Selectable)<\/p>\n\n\n\n

Stepper idle control plug in (Can be used for another 3 Medium current Outputs)<\/p>\n\n\n\n

Winbond 26Q16 Flash memory. Faster read and writes(Less wear on MCU)<\/p>\n\n\n\n

CAN Bus Communication (hardware, Up to Speeduino firmware if supported)<\/p>\n\n\n\n

Quality robust USB B connector (not the crappy USB Mini connectors)<\/p>\n\n\n\n

Aluminium cased<\/p>\n\n\n\n

All come with 34 and 26 Connectors and pins included. <\/p>\n\n\n\n

Full instructions included<\/p>\n\n\n\n

All hand assembled and tested in functioning car before sending out.<\/p>\n\n\n\n

Will require small firmware modification for pin map as with all other available STM32 Hardware versions.<\/p>\n\n\n\n

This is a Speeduino COMPATIBLE Board. (Like all other custom available boards advertised)<\/p>\n\n\n\n